|
Thread Number: 24304
Kirby Dual Sanitronic Speed Switch |
[Down to Last] |  |
| Post# 272168 , Reply# 1 3/16/2014 at 19:44 (3,693 days old) by vacman1961 (North Babylon, New York) | ||
|
Just remove the one screw holding the switch and take a paper clip and push it in the tab where the colored wires are plugged in to release the wires without damaging the light coat of solder on the wire ends and then just push the color wires into the correct color coded spaces, I usually use a needle nose plier to do that. | ||
Post# 272174 , Reply# 2 3/16/2014 at 20:01 (3,693 days old) by KirbyClassicIII  (Milwaukie, Oregon) |
||
 | ||
| Post# 272243 , Reply# 3 3/17/2014 at 13:23 (3,692 days old) by kirbymiele84 () | ||
|
Thanks to you both! | ||
| Post# 272783 , Reply# 4 3/20/2014 at 22:18 (3,689 days old) by BikerRay (Middle Earth) | ||
 | ||
| Forum Index: | 
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
