|
Thread Number: 40114
/ Tag: 50s/60s/70s Vacuum Cleaners
Some Scans from My 1956 Kirby Service Manual |
[Down to Last] |  |
Post# 425881 5/22/2020 at 19:03 (1,428 days old) by KirbyClassicIII  (Milwaukie, Oregon) |
||
Among them are the in-person views of the motor schematics (both those for 505-512 and 516 shown), and field and armature combinations and breakdown by letter codes in the unit serial number.
Another is of a service bulletin regarding a change to the brush roll for model 514. On models built up to serial no. 482-227, the brush roll adjusting screws were exactly the same as those for model 513 (1" long); the longer 1-3/8" screws were used on the 514 brush rolls for units built since serial no. 482-228. ~Ben This post was last edited 05/22/2020 at 19:43 | ||
| Post# 425885 , Reply# 1 5/22/2020 at 19:59 (1,428 days old) by Lesinutah (Utah) | ||
Thanks | ||
|
Post# 425886 , Reply# 2 5/22/2020 at 20:02 (1,428 days old) by KirbyClassicIII (Milwaukie, Oregon) |
||
|
LesinUtah | ||
| Forum Index: | 
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
;){kind=link}
;){kind=link}