|
Thread Number: 29267
/ Tag: 80s/90s Vacuum Cleaners
Is this just me? |
[Down to Last] |  |
| Post# 326842 , Reply# 1 6/13/2015 at 16:01 (3,233 days old) by gsheen (Cape Town South Africa) | ||
 | ||
| Post# 326850 , Reply# 2 6/13/2015 at 17:41 (3,233 days old) by vacuumlover (UK) | ||
|
@gsheen These seem to have grease in them. Ill open them up later and take a look. Thanks. | ||
| Post# 326874 , Reply# 3 6/14/2015 at 01:42 (3,233 days old) by gsheen (Cape Town South Africa) | ||
|
| ||
| Post# 326875 , Reply# 4 6/14/2015 at 04:29 (3,233 days old) by vacuumlover (UK) | ||
|
@gsheen The ones I get seem to be fine. Although thats only been a few months use. I can only say if they're crap after a long period of time. I would go to my bearings specialist but to far away. | ||
| Post# 326901 , Reply# 5 6/14/2015 at 15:58 (3,232 days old) by gsheen (Cape Town South Africa) | ||
|
What I noticed was when i was rebuilding motors especially higher speed ones that the bearings bought from various appliance spares wholsalers just didnt sound right. The motor ran fine but especially on their wind down they just didnt sound right. I remembered when I worked at Electrolux that the bearings we ordered had a special designation. I went to see my a bearing guy and he imediatly gave me a better bearing called a 608 C3 . The C3 is for high speed high load. Its also able to handle the heat better and once fitted the motors sound brand new again.
| ||
| Post# 326976 , Reply# 6 6/15/2015 at 14:26 (3,231 days old) by vacuumlover (UK) | ||
|
@gsheen Just sorted them out today and god were they dry | ||
| Post# 326992 , Reply# 7 6/15/2015 at 17:13 (3,231 days old) by gsheen (Cape Town South Africa) | ||
|
| ||
| Forum Index: | 
| Other Forums: |
|
|
|
|
|
Comes to the Rescue!
